The Ring light present on the Orbi router as well as the satellite flash white at some point. Additionally, you can also notice the light pulsing blue, amber, and magenta colors that represent the status of the internet connection on the device. But, why is an Orbi flashing white light? Let us find out with the help of information given ahead.
What Does White Flashing Light on Orbi Mean?
The Orbi router blinking white light case is most likely to occur when the router is powering up or it trying to establish a WPS connection with the device. However, the Orbi satellite flashes white when you have just powered it up and it is trying to connect to the Orbi router.
Why is Orbi Flashing White Light: Reasons
Considering that you have now understood the meaning of the Orbi blinking white, it is now time to understand why it happens.
1. Orbi Router Flashing White Light
If your router is flashing white light continuously then it has two reasons:
- Your router has failed to power up properly
- The router is taking longer than usual to establish a WPS connection
2. Orbi Satellite Flashing White Light
The white blinking Orbi light colors on satellite can be due to the following causes:
- The power supply to the satellite is unstable
- Your router and satellite are facing problems getting connected
Troubleshooting: Orbi Blinking White
Go through the hacks mentioned below to know what to do to fix the blinking white light on Orbi router or satellite:
1. Power Cycle the Network
Remove the power cords of your Orbi router and satellites from their respective wall outlets and keep them idle for a few moments. After that, restore the power and see if your Orbi devices get fully powered up. Also, ensure that the wall outlets into which you have plugged your Orbi units are functional. They must not be damaged in any case.
2. Press WPS/Sync Buttons in Correct Time Frame
The WPS connection will only be established successfully if you press the WPS button on your router and then on other device in a particular time frame i.e. 2 minutes. This will fix the white blinking light issue on the router. Also, ensure that you are not pressing the WPS button for more than 3-5 seconds.
3. Keep the Devices within Range
Another reason due to which you were seeing the flashing white light on your Orbi router and satellite was the connection failure (taking longer time than expected). This can happen if you keep your Orbi devices out of the range. Keep the following points in mind for a successful connection:
- The router should be in the range of the ISP provided ONT.
- If you have used an Ethernet cable, be sure that the router is connected to the modem with a non-damaged one.
- The satellites must be close to the router i.e. within 8-10 ft.
Bonus Point: You must be very sure that your Orbi router and satellite are placed in areas with zero signal interference. To ensure that, keep electromagnetic waves emitting devices, reflexive surfaces, and metal objects away from Orbi devices. Moreover, keeping the firmware updated can help you avoid a few hardware-related issues like the one you are facing.
To Sum Up
The Orbi flashing white light issue can create bigger problems for you if not addressed timely. Hopefully, after taking the help of the techniques highlighted in the write up, the white light on your router will turn off and that on the satellite will turn off after flashing blue for 3+ minutes.
